Additional Settings and Post Processing

Download the Settings Spreadsheet HERE- (Last update 03/13/2023)

Looking to Calibrate? Check out our tutorial on calibrating your resin / printer combo with our 3DRS Starship Calibration Test - Click Here

General printer Settings	Large Format	Small - Medium Build	Vroom Settings
Bottom Layers	12	8	8
Bottom Exposure Time	35-45	35-45	35-45
Light Off-Delay	1	1	0
Bottom Light-Off Delay	1	1	0
Bottom Lift Distance	12	8	8
Lift Distance	10	7	7
Bottom Lift Speed	40	65	65
Lifting Speed	65	100	240
Retracting Speed	100	150	240

General Post-Print Procedures 

We recommend post cleaning your prints using clean, high purity 99% IPA (Isopropyl Alcohol). For Best results, utilize Vortex mixers or Ultrasonic Cleaners to quickly remove excess resin for a maximum of 10-15 minutes. Avoid leaving prints to soak for extended periods. See Table A for general absorption rates. (Always wear safety glasses and protective gloves when handling 3D Printing Resin).

Completely dry your piece before post curing. Be sure all sides of your print receive equal light exposure to avoid unequal shrinkage on the overexposed side. Unequal cure can damage or dis-form your print. For best results, post cure your print until the surface tack is removed - Extended cure times can increase tensile strength which may be ideal for hollowed prints. When the material is properly post cured, All sides of your print should have equal color and your piece should be noticeably harder.

Table A: Percent weight gain before post curing "Green Solvent Resistance". 1x1x1 cm cubes printed with Table A settings on Creality LD-002R then immersed in respective solvent for 15 minutes. The lower the absorption rate, the less likely the print will experience surface deformations. 

IPA 99%	0 - .82 %
Acetone (not recommended)	3.2 %

 

Please do not hesitate to Contact Us with any questions or comments you may have. If you have the perfect settings on a specific printer you would like us to add, we welcome your input.